Individual differences in self-assessed health: An information-processing investigation of health and illness cognition.

In 2 studies, the relation between measures of self-assessed health (SAH) and automatic processing of health-relevant information was investigated. In Study 1, 84 male and 86 female undergraduate students completed a modified Stroop task. Results indicated that participants with poorer SAH showed enhanced interference effects for illness versus non-illness words. In Study 2, 27 male and 30 female undergraduate students completed a self-referent encoding task. Results offered a conceptual replication and extension of Study 1 by confirming the specificity of the relation between SAH measures and automatic processing of health (vs negative or positive general trait) information. These studies provide evidence that individual differences in SAH are reflected in schematic processing of health-relevant information. (PsycINFO Database Record (c) 2010 APA, all rights reserved)     

用FEM/FIM研究单壁碳纳米管束

利用范氏力将单壁碳纳米管样品组装到钨针尖上 ,用FEM/FIM对同一碳纳米管样品用热处理方法和场脱附方法进行了研究。场离子显微镜是具有原子级分辨能力的尖端表面分析工具 ,由场离子像推测这次组装的样品是由三根单壁碳纳米管突起组成的碳纳米管束。清洁碳纳米管束样品的场发射像和场离子像有极好的对应关系。场脱附后的碳纳米管束的场发射特性较好地符合Fowler Nordheim场发射模型。通过比较碳纳米管束吸附态和热处理后以及场脱附后的Fowler Nordheim曲线的斜率变化 ,得出碳纳米管束样品逸出功的变化 ,再结合场发射像的变化推断出场脱附与热处理结合是一种较理想的获得清洁碳纳米管表面的方法     

2010-2020年深圳市机动车发展和油气需求量预测

介绍了深圳市机动车发展现状,分别用趋势外推法、城市比较分析法和分类法预测了2010-2020年深圳市的机动车保有量,最后预测了机动车的油气需求量。     

基于分形特征的目标检测算法概述及仿真

对目前比较常用的基于分形特征的目标检测算法进行了概述，并给出了相应的仿真结果。从仿真结果我们看出基于多尺度分形参数的目标检测算法是一种比较精确的算法，但是计算量太大。从计算量和精确度双方面考虑快速的基于分维数和分形拟合误差的目标检测算法是一种不错的算法。     

城市燃气管网GIS系统的开发

随着我国天然气工业的不断发展，对于城市天然气管网的智能化管理已经作为一个全新的课题出现在燃气企业里。过去所使用的MIS系统（Management Information System），无论从效率、准确度、智能程度上讲，都已经不能满足目前城市燃气管网的精确管理。因此地理信息系统（Geography Information System，简称GIS系统）作为一种新的计算机管理系统应运而生，其主要特点是：有精确的管理、有标准的地图提供直接判断、空间关系与实物对应明确、管理直观。文章以企业对管理系统的需求以及技术可行性为出发点，阐述了GIS系统应具有的基本性能；同时结合燃气工程技术的发展，对燃气GIS系统做了应用开发研究；此外还对现阶段部分燃气GIS信息系统的不足做出了分析。     

香豆胶衍生物的化学结构及稳定性研究

将市售商品溶于水,用异丙醇沉析提纯,溶于0.1 mol/L NaNO3纯水溶液中,经0.5μm滤膜过滤后用水相凝胶渗透色谱法(GPC)测定,测得香豆胶(FG)、羟丙基香豆胶(HPFG)、阳离子香豆胶(CFG)的数均、重均相对分子质量Mn、Mw分别为:1.19×105、3.36×105,8.52×104、2.85×105,9.33×104、2.87×105。用甘露聚糖链在碱性条件下醚化时发生降解,解释两种改性FG的相对分子质量较FG低而多分散性(Mw/Mn)较FG高的测试结果。认为商品FG的1%水溶液黏度(1300 mPa.s)高于商品HPFG和CFG(分别为705和610 mPa.s)的原因是前者相对分子质量较高且残渣含量也较高(~10%,后二者为1%~2%)。HPFG的取代度为0.12,根据文献发表的13C-NMR数据确认HPFG分子链上羟丙基取代位置为C6。讨论了香豆胶(半乳甘露聚糖)的化学结构。热重分析法测定的热稳定性,HPFG高于CFG,CFG又高于FG。图6表3参13。     

A Low-Complexity Multiuser Detector for Asynchronous CDMA QPSK Adaptive Antenna Array Systems

This paper proposes a low complexity joint space-time multiuser detection algorithm for asynchronous DS/CDMA antenna array systems. The proposed multiuser detector is composed of an adaptive antenna array, used as a linear beamformer, and a sliding window decorrelator. A QPSK modulation scheme is used in order to increase bandwidth efficiency. Numerical results are given in terms of Bit Error Rate (BER) under the assumption of a frequency-selective Rayleigh slow fading channel. In particular, the proposed receiver is shown to be near-far resistant, even in worst fading cases, and to exploit completely array introduction while maintaining acceptable computational complexity. The proposed architecture avoids linear filter realization of the decorrelator, which is impractical in the case of a large number of users, and operates with relatively short data frames instead of the complete information sequence. Finally, this receiver is very flexible to changes in timing configuration.     

溶胶-凝胶生物玻璃多孔材料显微结构和生物活性的扫描电镜及红外光谱分析

本文利用溶胶．凝胶法制备了CaO-P2O5-SiO，系统生物活性玻璃，并以其为原料制备了用于骨修复及骨组织工程支架的块状生物活性材料。利用体外实验方法(invitro)结合x射线衍射(XRD)、扫描电子显微镜(SEM)和傅立叶变换红外光谱分析(FTIR)技术对不同烧结工艺制备的材料结构、晶相和生物活性的影响进行了分析研究。研究表明，经800℃和1100℃烧结5min的两种材料均有硅磷酸钙Ca5(PO4)2SjO4微晶相析出。烧结温度越高，析出微晶相的体积比例越大，材料的生物活性则越低。在模拟生理溶液中碳酸羟基磷灰石(HCA)只在烧结体中的玻璃颗粒表面形成，而在其硅磷酸钙Ca5(PO4)2SiO4微晶相表面未发现HCA形成。     

Determination of polymer–polymer interaction parameters using inverse gas chromatography

A modified method is discussed that is based on Farooque and Deshpande's method to obtain polymer–polymer interaction parameters using inverse gas chromatography (IGC) data. In the Farooque and Deshpande method, the ratio of the difference of probe–polymer interaction parameters between two polymers and the probe volume [(χ₁₂ ? χ₁₃)/V₁] is used as the abscissa. In the modified method, the ratio [(?₂χ₁₂ + ?₃χ₁₃)/V₁] is used as the abscissa. Experimental data previously reported for a poly(?‐caprolactone)‐polyepichlorohydrin (PCL/PECH) blend and a poly(ethyl acrylate)‐poly(vinyl propionate) (PEA/PVPr) blend are analyzed. It is found that the slopes obtained by the new method had smaller deviations from the theoretical values than the Farooque and Deshpande method. The standard deviations of both slopes and intercepts obtained from the new method are also smaller. Using the new method, the polymer–polymer interaction parameters obtained from the intercept are negative numbers for the PCL/PECH system and very small positive numbers for PEA/PVPr. Explanations are given for the probe and concentration dependency of the polymer–polymer interaction parameters that are generally observed in IGC studies. A new method for selecting the best probe for calculating the interaction parameter is discussed. © 2003 Wiley Periodicals, Inc. J Appl Polym Sci 90: 671–680, 2003